The CardBoard
Tip for making surgical masks fit better - Printable Version

+- The CardBoard (https://thecardboard.org/board)
+-- Forum: Emergency (https://thecardboard.org/board/forum-11.html)
+--- Forum: Covid-19 (https://thecardboard.org/board/forum-12.html)
+--- Thread: Tip for making surgical masks fit better (/thread-20059.html)



Tip for making surgical masks fit better - allrightynow - 07-11-2020

https://www.insider.com/doctor-tiktok-shows-how-to-make-face-mask-fit-better-2020-7

In case you haven't seen it before, just have to tie a couple of knots. I've been trying it out for a few days and it can take a little fiddling to get the best fit/angle, but seems to be much tighter, which presumably  does a better job filtering.


RE: Tip for making surgical masks fit better - akiddoc - 07-11-2020

There are also the rubber band and tourniquet methods.

https://www.ncbi.nlm.nih.gov/pmc/articles/PMC7179060/


RE: Tip for making surgical masks fit better - Erika - 07-11-2020

https://www.fixthemask.com/make-it#Manufacture-the-fix The rubber one piece works better than the 3 rubber bands for me. Great solution.


RE: Tip for making surgical masks fit better - magnus - 07-11-2020

Thanks for the tips!


RE: Tip for making surgical masks fit better - M T - 07-11-2020

Agreed, thanks!


RE: Tip for making surgical masks fit better - allrightynow - 07-11-2020

I was actually using an outer nylon stocking layer over a surgical mask (yes, pantyhose haha)
https://www.npr.org/sections/goatsandsoda/2020/04/22/840146830/adding-a-nylon-stocking-layer-could-boost-protection-from-cloth-masks-study-find
before when going to higher risk places, but the knot method seems better for me so far. I had tried the 3 rubber band method before, but it didn't seem comfortable for longer periods of use. I was going to try the one piece rubber sheet but the test data on fixthemask seemed to show the filtration improvement wasn't as good without fiddling with cushioning around the nose so I never did.


RE: Tip for making surgical masks fit better - fullmetal - 07-12-2020

For a tighter fit without hurting your ears, you can try looking for ear savers:
https://www.amazon.com/Cosplay-Life-Saver-Medical-Mask/dp/B087ZR9FGV
https://www.industryweek.com/technology-trends/article/21128668/one-million-3d-printed-ear-savers-going-to-frontline-workers

They are easily created using 3D printers if you have access to one.  Or you can buy them online.

There's a DIY cloth-and-button version here:
https://www.thecraftpatchblog.com/easy-diy-ear-savers/